The upper blade and the lower blade of the multi cutter splitter form a group to form a cutting unit. They were group A, group B, group C and group 3. The whole cutting process is divided into three stages. Group a blade first cuts 40% of the circuit board, and then group B blade runs again on the groove cut by group a blade to complete 40% cutting amount again. Finally, group C blades cut the last 20% and trim. Compared with the traditional one-off cutting method, the stress produced in the cutting process is reduced by more than 80% due to the small amount of cutting each time. The edges of the separated boards are flat and smooth, and the board surface is very flat without distortion or warpage.
The multi cutter board dividing machine can split the whole board at one time, and can be connected up and down to realize unmanned operation. It is not only easy to install, but also easy to set up, which can save a lot of staff, time and manpower. It takes less space and saves operation time to the greatest extent. The multi cutter dividing machine can cut multiple groups of cutting tools at the same time, and divide the whole plate at one time, so as to ensure that the separated plate does not deform and warpage at the same time, with high efficiency and strict control of deformation degree.
The imported TBI screw is used in the multi cutter dividing machine, with high positioning accuracy and small force on the cutter head. The door opening protection device with high safety performance is adopted for the multi cutter board splitter. The machine can automatically feed and cut the plate with higher efficiency. Up and down docking paperboard machine, saving labor. The blade material of multi blade plate splitter is imported high speed steel. The distance between the blade and the front of the blade is at least 3mm, and the thickness of the blade is 0.2mm. The size of the meson is customized according to the size of the printed circuit board. The service life of the blade is 100000 times. The blade can be repeatedly overturned, ground and reused. According to the specific situation, the blade can be rotated and polished 2-3 times.
The multi knife plate splitter adopts multiple groups of upper and lower blades to break at the same time. A caster with adjustable foot cup is installed at the bottom of the equipment, which is convenient for the equipment to move. It needs to be fixed stably when it is not moved. The gap between the upper and lower blades can be adjusted according to the V-shaped cutting distance of printed circuit board. The precision is controlled within 0.1 mm. The distance between two adjacent groups of blades can be adjusted between 10 mm and 25 mm. The required width can be adjusted quickly. The tool starts to run, multiple sets of cutters cut the product at the same time, the whole block is divided at one time, and the product conveyor belt starts to run. The conveyor belt stops immediately after the product separation to ensure that the product stays on the conveyor belt.
The above explanation is the function advantages of the multi knife splitter. I hope it can help you after reading it. If you want to know more about the functional advantages of the multi cutter board splitter, please contact customer service online or call our service hotline (top right corner of the website) for consultation. We will wholeheartedly provide you with high-quality service!